Technics® 1200/1210 series
'PlugNPlay' LED Kits Installation Guide
|
Technics® 1200/1210 series 'PlugNPlay' LED Kits Installation Guide |
|
| 33/45 & Pitch Slider Guide | PopUp Guide |
Terms of Use and Disclaimer |
| The information contained
herein is provided for the sole purpose of illustration of
part replacement. And should be used at your own descretion as a guide only.
Although the kits have been made
for the lay-person to self install. As with any electrical
appliance, any warranty may be voided and should be performed by an
authorized service center for the respective device. As indicated by the
original equipment manufacturer's labeled warning. By no means shall the manufacturer Technology Transplant® or it's resellers be held responsible for any damages or injury that may occur from it's installation or use of the guide. By use of this guide the user assumes full responsibility of person and equipment. As with any electrical appliance. Use good judgment of your own capabilities as to whether this product or guide is right for you. © 2010 Technology Transplant. |
|
General Disassembly Guide |
IMPORTANT 
Please don't forget safety and unplug your unit while servicing!
Remove head-shell and secure and lock the tone-arm.
Remove the top plate by using your
two fore fingers or index fingers. It should be easy to remove.
Sometimes, with second hand
turntables. Gunk or even glue can be found from the previous owner that
may make it more difficult to pull off!
Remove the (5) screws that hold the black plastic protector (photo middle) and remove as shown (right).
Disconnect the 3 cable sockets:
"C202" for the Pitch Slider PCB, "C209" for the 33-45 Strobe PCB and , "DP122 Lamp" for the PopUp.
Before placing the turntable upside as shown below. It must be centrally supported by a circular object underneath it at center where the tone arm is located.
The turntable should be 'floating' above your workspace.
Such objects as a storage bin or circular plastic bucket, make great balanced supports you can find around the house.
Remove (4) Stand-Off feet by turning counter-clockwise. Do NOT PULL feet out, they turn and unscrew off!
Green
section shows (4)
Longest screws, which are located underneath the stand-off feet removed in
previous photo.
Yellow
section (6) Medium screws.
Orange section (12)
Small screws (8 outside rim, 4 inner rim).
The leads for 'phono' (left) and
'power' (right) must exit the rubber base.
The rubber base is rather heavy
and requires both hands to pull up and off the metal frame of the turntable.
Be sure that the leads are loose to freely exit as lifting up the base.
Open view. Pitch slider (left), PopUp Lamp assembly (middle) and 33-45 strobe [on-off] (right).
Gently slide out the cabling from the insertion holes for each of the 3 units for replacement.
|
Technics® 1200/1210 series 'PlugNPlay' LED Kits Installation Guide |
|
| 33/45 & Pitch Slider Guide | PopUp Guide |
Terms of Use and Disclaimer |
| The information contained
herein is provided for the sole purpose of illustration of
part replacement. And should be used at your own descretion as a guide only.
Although the kits have been made
for the lay-person to self install. As with any electrical
appliance, any warranty may be voided and should be performed by an
authorized service center for the respective device. As indicated by the
original equipment manufacturer's labeled warning. By no means shall the manufacturer Technology Transplant® or it's resellers be held responsible for any damages or injury that may occur from it's installation or use of the guide. By use of this guide the user assumes full responsibility of person and equipment. As with any electrical appliance. Use good judgment of your own capabilities as to whether this product or guide is right for you. © 2010 Technology Transplant. |